Plastic Screw Preload and Creep Relaxation Control Guide
plastic screw Preload and Creep Relaxation Control Guide
plastic screws lose preload over time after assembly—stress or creep relaxation. Compared with metal, plastics have low modulus and pronounced viscoelasticity; heat and load accelerate relaxation, loosening joints. This guide covers mechanisms, testing and control.
Understanding relaxation allows design compensation, avoiding loosening, noise or seal failure from preload decay.
Preload Formation
Preload comes from screw elongation and thread engagement, but low stiffness means far less preload per turn than metal. Excess preload crushes plastic or strips threads—the torque window is narrow.
Friction matters—higher plastic friction lowers torque-to-preload efficiency; actual clamp load needs testing.
Creep Relaxation Mechanism
Under constant strain, polymer chains slide and rearrange, dropping stress over time. Higher temperature speeds this, especially near the glass transition.
Moisture changes mechanical properties—nylons lose stiffness and change dimensions when absorbing water, worsening decay. Media and UV aging also affect long-term performance.
Test Methods
A common method applies initial preload at constant temperature and logs clamp force over time via a sensor, yielding relaxation rate and stabilization time. Test temperatures should span service range.
Nut-rotation torque methods indirectly assess by measuring loosening torque drop after aging. Combining both judges relaxation and reliability.
Influencing Factors
Material dominates—POM, PA, PC and PP differ; glass-filled grades are stiffer and relax less. Screw length, diameter and thread form affect retention.
Torque, temperature, humidity and media interact. In long high-temperature service, even adequate initial preload may decay quickly.
Design and Assembly Compensation
Add elastic elements—spring or wave washers, elastic plates—to compensate via elastic deformation. Longer engagement and metal inserts improve retention.
Cap torque to avoid crushing; use metal parts or inserts where clamp must persist; design re-tightening features for maintenance.
Validation and Maintenance
Validation uses accelerated aging at service temperature and measures residual preload against clamp requirements. Production verifies parameters by first article and sampling.
For long reliability, set periodic inspection and re-tightening, especially in hot, humid or vibrating joints—include relaxation in maintenance.
Test Design for Temperature Effects
Relaxation is temperature-sensitive; test at ambient, high temperature and cycling. Constant temperature compares materials; cycling approaches real service.
Fixtures must account for thermal expansion—deformation biases force readings. Load after stabilization to avoid extra relaxation during heating.
Express results as residual preload ratio and plot time-residual curves to judge stabilization time for design margin.
